PHP Fatal error: PHP Startup: apc_mmap: mmap failed: in Unknown on line 0

PHP Fatal error: PHP Startup: apc_mmap: mmap failed: in Unknown on line 0

July 25, 2026 · Illustrated author avatarBy Stefan Bogdanescu
PHP Fatal error: PHP Startup: apc_mmap: mmap failed: in Unknown on line 0

Solving the APC Installation Issue on PHP

Are you trying to set up APC for your PHP environment, particularly for Magento? You’re not alone if you’ve encountered a stubborn “PHP Startup: apc_mmap: mmap failed” error during the installation process. Let’s walk through this issue step by step and find a resolution.

Understanding the APC Error

The PHP Startup: apc_mmap: mmap failed error typically occurs when PHP is struggling to allocate shared memory for APC, usually due to insufficient permissions or hardware limitations. The segmentation fault that follows suggests a serious issue with your installation or configuration.

Your Current Setup Analysis

You’ve done an excellent job so far by installing APC via PECL and configuring it through the apc.ini file in /etc/php.d/. However, let’s explore some potential culprits for this persistent error.

Permissions Issues

One common reason for this problem is incorrect permissions on the shared memory files that APC tries to create. The directory /tmp/ often needs specific permissions for APC to function correctly.

To verify and correct these permissions, you can use the following commands:

# Check current permissions for /tmp/
ls -ld /tmp

# If necessary, change permissions (Be cautious with this step)
sudo chmod 775 /tmp

Shared Memory Limitations

Another potential issue lies in your system’s shared memory configuration. APC requires a certain amount of SHM space to operate effectively.

You can check your current SHM settings using the command:

cat /proc/sys/kernel/shmmax

If this value is lower than what you’ve specified with apc.shm_size, consider increasing it by editing /etc/sysctl.conf and adding or modifying the line for kernel.shmmx.

PHP Configuration Problems

Even if your APC configuration in apc.ini looks correct, a misconfigured PHP environment can cause this error. Double-check your main PHP configuration file (php.ini) to ensure there are no conflicting directives.

Resolving the “mmap Failed” Error

Given that you’re still encountering issues even after removing all lines from apc.ini, let’s try some alternative troubleshooting steps:

Check Your PHP Version Compatibility

The error message suggests a compatibility issue with your PHP version (5.4). Ensure that the APC extension you’ve installed matches this PHP version.

You can verify this by checking the APC documentation or using the -v flag when reinstalling it:

pecl install -v apc

Review Your System Resources

Examine your system’s available memory and swap space. If these resources are critically low, PHP might fail to allocate memory for shared memory operations.

Use commands like free -m or cat /proc/meminfo to analyze your current memory status.

Conclusion: Get APC Running Smoothly

While this issue can be frustrating, there are several avenues you can explore to resolve the “PHP Startup: apc_mmap: mmap failed” error. By focusing on permissions, shared memory settings, and PHP version compatibility, you should be able to find a solution.

Remember, it’s essential to monitor your system’s resource usage and ensure that your configuration files are free of syntax errors or conflicting directives.

For more in-depth guides on PHP optimization and extension management, consider reading our PHP Extension Best Practices article.

Security Configuration Errors

Our network